![]() Fits the look and feel as well! Note I also replaced the hard disk drive with a Compact Flash card The floppy and hard disk caddy from the Compaq Portable 386 This newer floppy disk drive fits perfectly in the slot designed for the 5.25″ drive. ![]() ![]() However, the boot disk must be a 720KB 3.5″ disk – it won’t boot from the high density 1.44 MB disks. Luckily Compaq configured the Portable 386’s ROM to accept 3.5″ 1.44 MB floppy drives, selectable from the diagnostics utility. The default floppy drive that comes with a Compaq Portable 386 is the 5.25-inch 1.2MB variety – it accepts 360KB and 1.2 MB disks. Make sure you’ve swapped out the old battery before making changes to the configuration – if you don’t, once you’ve powered down the computer, you will lose all your settings. The setup / diagnostic programs the CMOS chip that stores settings about the computer’s configuration. You will need to unzip the file and write the image file to a 720K disk, then insert the disk and switch on the computer. ![]() The first thing you need to get working is the floppy drive, as you will need to run a configuration utility to set up the computer before you can get past POST. You can jump to:Ĭonfiguration / Setup Disk for The Compaq Portable 386 This section looks at the floppy drive, the 720K disks it accepts, and the Compaq Diagnostics program to configure the computer. This is the 4th post in a 6 post series on the Compaq Portable 386 Computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |